@▷ 555 DC-AC Inverter | Diagram for Schematic

555 DC-AC Inverter

Source : http://www.uoguelph.ca/~antoon/circ/555dcac.html

Parts List:

R1 = 10K

R2 = 100K

R3 = 100 ohm

R4 = 50K potmeter, Linear

C1,C2 = 0.1uF

C3 = 0.01uF

C4 = 2700uF

Q1 = TIP41A, NPN, or equivalent

Q2 = TIP42A, PNP, or equivalent

L1 = 1uH

T1 = Filament transformer, your choice

This DC-to-AC inverter schematic produces an AC output at line frequency and voltage. The 555 is configured as a low-frequency oscillator, tunable over the frequency range of 50 to 60 Hz by Frequency potentiometer R4.
The 555 feeds its output (amplified by Q1 and Q2) to the input of transformer T1, a reverse-connected filament transformer with the necessary step-up turns ratio. Capacitor C4 and coil L1 filter the input to T1, assuring that it is effectively a sine wave. Adjust the value of T1 to your voltage.

The output (in watts) is up to you by selecting different components.

Input voltage is anywhere from +5V to +15Volt DC, adjust the 2700uF cap’s working voltage accordingly.
Replacement types for Q1 are: TIP41B, TIP41C, NTE196, ECG196, etc. Replacement types for Q2 are: TIP42B, TIP42C, NTE197, ECG197, etc. Don’t be afraid to use another type of similar specs, it’s only a transistor… ;-)

If the whole thing is working, good. If not, relax and don’t get frustrated. Do the following checks:
1) You have connected the filament transformer in REVERSE yes?
2) If not, disconnect the power and reverse. If you have, disconnect the transformer and measure the voltage after L1 and ground.
3) Just in case, GROUND for this circuit is same as negative (-).
4) Q1/Q2 are oposites, e.i. npn/pnp.
5) Is your 555 perhaps defective? Disconnect R3 from pin 3 and check pin 3 for a pulse.
6) Check your transistors to make sure they are not defective.

"555 DC-AC Inverter Search Tags"
555, basic electr
Advertiser