@▷ Water Alarm | Diagram for Schematic

Water Alarm

Water Alarm



 

Water Alarm

 


This is a simple water alarm. At the heart of this circuit is a small water sensor. For fabricating this water sensor, you need two foils—an aluminium foil and a plastic foil. You can assemble the sensor by rolling aluminium and plastic foils in the shape of a concentric cylinder. Connect one end of the insulated flexible wire on the aluminium foil and the other end to resistor R2. Now mount this sensor inside the water tap such that water can flow through it uninterrupted. To complete the circuit, connect another wire from the junction of pins 2 and 6 of IC1 to the water pipeline or the water tap itself.


The working of the circuit is simple. Timer 555 is wired as an astable multivibrator. The multivibrator will work only when water flows through the water tap and completes the circuit connection. It oscillates at about 1 kHz. The output of the timer at pin 3 is connected to loudspeaker LS1 via capacitor C3. As soon as water starts flowing through the tap, the speaker starts sounding, which indicates resumption of water supply. It remains ‘on’ until you switch off the circuit with switch S1 or remove the sensor from the tap. The circuit works off a 9V battery supply. The water sensor is inserted into the water tap. Connect the lead coming out from the junction of 555 pins 2 and 6 to the body of the water tap. Use on/off switch S1 to power the circuit with the 9V PP3 battery.


Advertiser